Untitled Document

Hard wired control solutions

The original method of control before the development of infra-red and radio systems was the hard wired wall switch, the low cost and flexibility in matching finishes to existing light switches and plug sockets has ensured it remains a popular choice.

Permanent switch -Our standard latching switch module (stays down when pressed) can be used in customers own switch plates or supplied in one of our own housings. Suitable for 240 and low volt blind systems.

Momentary switch -Non-latching version of above (switch needs to be held on), particularly usful with venetian and vertical blinds to give greater control for

tilting slats. Suitable for 240 and low volt blind systems.

CLICK TO DOWNLOAD WIRING DIAGRAMS

240 VOLT TOGGLE SWITCH

LOW-VOLT TOGGLE SWITCH

KEY SWITCH

PUSH BUTTON WITH CM1 CONTROLLER

Key switch -Used for situations where a higher level of security is required over control. Recommended for use with roller shutters and commercial facilities to prevent unauthorised use of blinds. Suitable for both 240 and low volt operations.

Push button -For use with compatible control systems such as our CM units that have facility for volt free or low volt trigger inputs. Available in a range of colours and finishes.

	Examples of custom switch plates
	All our hard wired switch range can be specified to match existing room hardware, and engraved to customer requirements.

Remember to Always Keep Blind Cords Out of Reach of children!